Description.
Notes.
This is a simple, but very useful
circuit that can be used to transmit telephone conversations. When the
telephone receiver is on hook the voltage across the lines will be about
48 volts. The preset R7 is so adjusted to obtain a 24.7 V across
between the cathode of D2 and ground. At this voltage the Zener diode D2
will be in breakdown and the transistor T1 will conduct. This makes the
transistor T2 OFF. When the receiver is off hook, the line voltage
drops to about 11 volts. This makes the transistor T1 OFF and
subsequently the T2 ON. The T2 in switched ON condition will provide a
DC path for the transistor T3 used in the FM transmitter section.
The transistor T3 is wired as a common
emitter radio frequency oscillator. In simple words the transistor T2
serves as an ON/OFF switch for this oscillator. The modulated signal
will be available at the collector of transistor T3 and the signal id
fed to the antenna via capacitor C5.
Circuit diagram with Parts list.Notes.
- Assemble the circuit on a good quality PCB.
- For L1 make 45 turns of 36 SWG enameled copper wire on the resistor R6 itself.
- The resistor R6 must be a 1M, 1 watt resistor.
- For L2 make 3 turns of 21 SWG enameled copper wire on a 12 mm plastic former.
- For antenna, use a 1 meter insulated copper wire.
- The capacitor C3 can be a 50pF trimmer.